Geschrieben von Gh0st am 17.03.2006 um 19:00:
Hier das müsste sie eigentlich sein...ins Internet komm ich net aber brennen geht...^^
{\rtf0\ansi
\ansicpg1252
{\fonttbl
{\f0\fswiss\fcharset0 Helvetica;}}
{\info
{\creatim \yr2006\mo3\dy17\hr18\min46\sec26}
{\revtim \yr2006\mo3\dy17\hr18\min54\sec8}
{\printim \yr2006\mo3\dy17\hr18\min48\sec12}
}
\paperw12240\paperh15840\margl1800\margr1800\margt1440\margb1440
\ftnbj\aenddoc\ftnrstcont\aftnrstcont\ftnnar\aftnnrlc
\sectd
\f0\fs20 PCI: Assigned IRQ 5 for device 00:07.2\par
usb-uhci.c: USB UHCI at I/O 0x1020, IRQ 5\par
usb-uhci.c: Detected 2 ports\par
usb.c: new USB bus registered, assigned bus number 1\par
hub.c: USB hub found\par
hub.c: 2 ports detected\par
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver\par
usbdevfs: remount parameter error\par
hub.c: new USB device 00:07.2-2, assigned address 2\par
usb.c: USB device 2 (vend/prod 0x46d/0xc01b) is not claimed by any
active driver
.\par
mice: PS/2 mouse device common for all mice\par
usb.c: registered new driver hiddev\par
usb.c: registered new driver hid\par
input: USB HID v1.10 Mouse [Logitech USB-PS/2 Optical Mouse] on usb1:2.0
\par
hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik <vojtech@suse.cz>\par
hid-core.c: USB HID support drivers\par
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ
SERIAL_PCI IS
APNP enabled\par
ttyS00 at 0x03f8 (irq = 4) is a 16550A\par
ttyS01 at 0x02f8 (irq = 3) is a 16550A\par
parport0: PC-style at 0x378 [PCSPP,TRISTATE,EPP]\par
parport_pc: Via 686A parallel port: io=0x378\par
parport0: PC-style at 0x378 [PCSPP,TRISTATE,EPP]\par
parport_pc: Via 686A parallel port: io=0x378\par
Linux Tulip driver version 0.9.15-pre12 (Aug 9, 2002)\par
PCI: Enabling device 00:09.0 (0000 -> 0003)\par
PCI: No IRQ known for interrupt pin A of device 00:09.0. Please try
using pci=bi
osirq.\par
PCI: Setting latency timer of device 00:09.0 to 64\par
eth0: ADMtek Comet rev 17 at 0x1c00, 00:90:96:1F:CB:09, IRQ 0.\par
Via 686a/8233/8235 audio driver 1.9.1-ac3\par
PCI: Found IRQ 4 for device 00:07.5\par
IRQ routing conflict for 00:0c.1, have irq 10, want irq 4\par
PCI: Setting latency timer of device 00:07.5 to 64\par
via82cxxx: timeout while reading AC97 codec (0xAA0000)\par
via82cxxx: timeout while reading AC97 codec (0x800000)\par
via82cxxx: timeout while reading AC97 codec (0x800000)\par
ac97_codec: AC97 codec, id: ADS97 (Analog Devices AD1886)\par
via82cxxx: board #1 at 0x1800, IRQ 4\par
Linux agpgart interface v0.99 (c) Jeff Hartmann\par
agpgart: Maximum main memory to use for agp memory: 440M\par
agpgart: Detected Via Apollo Pro chipset\par
agpgart: AGP aperture is 128M @ 0xe8000000\par
FAT: Did not find valid FSINFO signature.\par
Found signature1 0x4e0005 signature2 0xd6e80000 sector=1.\par
VFS: Can't find a valid FAT filesystem on dev 03:01.\par
FAT: Did not find valid FSINFO signature.\par
Found signature1 0x4e0005 signature2 0xd6e80000 sector=1.\par
VFS: Can't find a valid FAT filesystem on dev 03:01.\par
NTFS driver v1.1.22 [Flags: R/W MODULE]\par
hub.c: new USB device 00:07.2-1, assigned address 3\par
usb.c: USB device 3 (vend/prod 0x5ac/0x1205) is not claimed by any
active driver
.\par
Initializing USB Mass Storage driver...\par
usb.c: registered new driver usb-storage\par
Initializing USB Mass Storage driver...\par
usb.c: registered new driver usb-storage\par
scsi2 : SCSI emulation for USB Mass Storage devices\par
usb-uhci.c: interrupt, status 3, frame# 1324\par
Vendor: Apple Model: iPod Rev: 1.62\par
Type: Direct-Access ANSI SCSI revision: 02\par
Attached scsi removable disk sda at scsi2, channel 0, id 0, lun 0\par
SCSI device sda: 7999488 512-byte hdwr sectors (4096 MB)\par
sda: Write Protect is off\par
sda: sda1 sda2\par
WARNING: USB Mass Storage data integrity not assured\par
USB Mass Storage device found at 3\par
USB Mass Storage support registered.\par
Journalled Block Device driver loaded\par
VFS: Can't find ext3 filesystem on dev sd(8,1).\par
VFS: Can't find ext2 filesystem on dev sd(8,1).\par
Unable to identify CD-ROM format.\par
sh-2021: reiserfs_read_super: can not find reiserfs on sd(8,1)\par
FAT: bogus logical sector size 23597\par
VFS: Can't find a valid FAT filesystem on dev 08:01.\par
SGI XFS snapshot 2.4.22-2003-09-03_04:09_UTC with ACLs, realtime, no
debug enabl
ed\par
SGI XFS Quota Management subsystem\par
XFS: bad magic number\par
XFS: SB validate failed\par
VFS: Can't find a HFS filesystem on dev 08:01.\par
EFS: 1.0a -
http://aeschi.ch.eu.org/efs/\par
FAT: Did not find valid FSINFO signature.\par
Found signature1 0x4e0005 signature2 0xd6e80000 sector=1.\par
VFS: Can't find a valid FAT filesystem on dev 03:01.\par
FAT: Did not find valid FSINFO signature.\par
Found signature1 0x4e0005 signature2 0xd6e80000 sector=1.\par
VFS: Can't find a valid FAT filesystem on dev 03:01.\par
}
). Folgende Dinge solltest du klären:
